U3472 Ford Ka OBD Code

OBD/2 U3472 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC U3472 as an indication of a hard fault.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

U3472 Ford Ka Error Code Repair Process :

The rule of U3472 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of cylinder head overtemperature protection active. Likewise, overriding the OBD U3472 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Ford Ka U3472 OBD2 Code

A common cause of code U3472 is the failure of Cylinder Head Overtemperature Protection Active, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Clogged or faulty fuel injector (s)
Intake Valve Timing Control Solenoid Valve circuit poor electrical connection
Radio frequency interference (RFI)

U3472 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3472 Ford Ka OBD Code

U3472 Ford Ka Error Code Repair Process :

Common Causes of Ford Ka U3472 OBD2 Code

U3472 code for other Ford cars