U3296 Trouble Code

View U3296 obd/2 error code description and symptoms. U3296 engine photo

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

U3296 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U3296 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If dual alternator lower circuit malfunction/ manifold absolute pressure (map) sensor circuit intermittent low voltage so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the dual alternator lower circuit malfunction/ manifold absolute pressure (map) sensor circuit intermittent low voltage.

U3296 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Common Causes of U3296

A common cause of code U3296 is the failure of Dual Alternator Lower Circuit Malfunction/ Manifold Absolute Pressure (MAP) Sensor Circuit Intermittent Low Voltage, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Faulty Fuel injector
Failures of clutch motion/travel sensors.
Fuel Injectors circuit poor electrical connection

U3296 code for all cars

You can view according U3296 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+U3296 Ford Tourneo Connect

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy