U3094 Mitsubishi Ek-wagon OBD Code

OBD/2 U3094 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

U3094 Mitsubishi Ek-wagon Error Code Repair Process :

If your catalyst temperature sensor low input (bank 2) check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U3094 and engine control unit are in charge of monitoring a bunch of different catalyst temperature sensor low input (bank 2), and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Mitsubishi Ek-wagon U3094 OBD2 Code

A common cause of code U3094 is the failure of Catalyst Temperature Sensor Low Input (Bank 2), but there are several other possible causes as well, such as ;

Damaged VCT phaser
Engine Control Module (ECM)
Ignition misfiring
Faulty Crankshaft Position Sensor (POS)

U3094 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3094 Mitsubishi Ek-wagon OBD Code

U3094 Mitsubishi Ek-wagon Error Code Repair Process :

Common Causes of Mitsubishi Ek-wagon U3094 OBD2 Code

U3094 code for other Mitsubishi cars