U2912 Toyota Crown OBD Code

OBD/2 U2912 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

U2912 Toyota Crown Error Code Repair Process :

The rule of U2912 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of fuel rail pressure sensor circuit malfunction. Likewise, overriding the OBD U2912 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Toyota Crown U2912 OBD2 Code

A common cause of code U2912 is the failure of Fuel Rail Pressure Sensor Circuit Malfunction, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty Variable Camshaft Timing (VCT) position solenoid
Faulty TCM or TCM programming
Faulty Variable Camshaft Timing (VCT) position solenoid

U2912 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2912 Toyota Crown OBD Code

U2912 Toyota Crown Error Code Repair Process :

Common Causes of Toyota Crown U2912 OBD2 Code

U2912 code for other Toyota cars