U2912 Mercury Lynx OBD Code

OBD/2 U2912 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

U2912 Mercury Lynx Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U2912 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If fuel rail pressure sensor circuit malfunction so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the fuel rail pressure sensor circuit malfunction.

Common Causes of Mercury Lynx U2912 OBD2 Code

A common cause of code U2912 is the failure of Fuel Rail Pressure Sensor Circuit Malfunction, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Faulty Intake Valve Timing Control Solenoid Valve
Fuel tank leaking
Faulty select solenoid

U2912 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2912 Mercury Lynx OBD Code

U2912 Mercury Lynx Error Code Repair Process :

Common Causes of Mercury Lynx U2912 OBD2 Code

U2912 code for other Mercury cars