U2885 Trouble Code

View U2885 obd/2 error code description and symptoms. U2885 engine photo

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

As the engine heats up and combustion becomes easier and more complete, the PCM will command the idling control valve to increase the amount of air entering the engine to suit the changing conditions. However, when the load on the engine changes, say, when some electrical consumers or other systems are either turned on or off, the PCM adapts the signal voltage to the idle control valve to ensure that the idling speed remains stable, and at the RPM specified by the manufacturer.

U2885 Error Code Repair Process :

If your o2 sensor heater circuit malfunction (bank 2 sensor 2) check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U2885 and engine control unit are in charge of monitoring a bunch of different o2 sensor heater circuit malfunction (bank 2 sensor 2), and if they get a reading that's a little out of whack, up pops the check engine light.

U2885 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Common Causes of U2885

A common cause of code U2885 is the failure of O2 Sensor Heater Circuit Malfunction (Bank 2 Sensor 2), but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Damaged ECM
Internal electrical failures in actuator motors/solenoids.

U2885 code for all cars

You can view according U2885 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+U2885 Volkswagen Export

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy