U2790 Chevrolet C-10 OBD Code

OBD/2 U2790 error code description and symptoms.

Vehicle Speed Sensor (VSS) Intermittent Indicates the powertrain control module (PCM) detected an error in the vehicle speed information. Vehicle speed data is received from either the vehicle speed sensor (VSS), transfer case speed sensor (TCSS), anti-lock brake system (ABS) control module, generic electronic module (GEM), or central timer module (CTM). This DTC is set the same way as U2790. However, it is intended to flash the transmission control indicator lamp (TCIL) for first time VSS circuit error/malfunctions. Refer to possible causes for U2790

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

U2790 Chevrolet C-10 Error Code Repair Process :

The scent may U2790 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such U2790, so if the inside of your car scp (j1850) invalid or missing data for tires as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Common Causes of Chevrolet C-10 U2790 OBD2 Code

A common cause of code U2790 is the failure of SCP (J1850) Invalid or Missing Data for Tires, but there are several other possible causes as well, such as ;

EVAP system hose leaking
Failures of clutch motion/travel sensors.
Engine Control Module (ECM)
Variable Camshaft Timing (VCT) position circuit is open or shorted

U2790 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2790 Chevrolet C-10 OBD Code

U2790 Chevrolet C-10 Error Code Repair Process :

Common Causes of Chevrolet C-10 U2790 OBD2 Code

U2790 code for other Chevrolet cars