U2746 Trouble Code

View U2746 obd/2 error code description and symptoms. U2746 engine photo

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

U2746 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U2746 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If scp (j1850) invalid or missing data for climate control (hvac) so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the scp (j1850) invalid or missing data for climate control (hvac).

U2746 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Common Causes of U2746

A common cause of code U2746 is the failure of SCP (J1850) Invalid or Missing Data for Climate Control (HVAC), but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Erratic camshaft position due to low oil pressure
Fuel injectors may be faulty
1Camshaft Position Sensor circuit poor electrical connection

U2746 code for all cars

You can view according U2746 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+U2746 Mazda Cu-x

+U2746 Isuzu I-370

+U2746 Innocenti C

+U2746 Mercedes Clk 270

+U2746 Warwick Gt

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy