U2723 Jaguar Sovereign OBD Code

OBD/2 U2723 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

U2723 Jaguar Sovereign Error Code Repair Process :

The scent may U2723 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such U2723, so if the inside of your car scp (j1850) invalid or missing data for experimental #3 as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Common Causes of Jaguar Sovereign U2723 OBD2 Code

A common cause of code U2723 is the failure of SCP (J1850) Invalid or Missing Data for Experimental #3, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty starter motor
Faulty Crankshaft Position Sensor (POS)

U2723 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2723 Jaguar Sovereign OBD Code

U2723 Jaguar Sovereign Error Code Repair Process :

Common Causes of Jaguar Sovereign U2723 OBD2 Code

U2723 code for other Jaguar cars