U266E Trouble Code

View U266E obd/2 error code description and symptoms. U266E engine photo

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code U266E, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code U266E on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

U266E Error Code Repair Process :

The rule of U266E code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of scp (j1850) invalid or missing data for primary id. Likewise, overriding the OBD U266E error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

U266E is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Common Causes of U266E

A common cause of code U266E is the failure of SCP (J1850) Invalid or Missing Data for Primary Id, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty select solenoid
Fuel filler cap remains open or fails to close
Loss of ground.

U266E code for all cars

You can view according U266E DTC for your car model. We selected several models to see obd2 solutions click and view it.

+U266E Volkswagen 181

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy