U2611 Trouble Code

View U2611 obd/2 error code description and symptoms. U2611 engine photo

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

Regardless of the design though, the purpose of all clutch actuating systems is to improve the driving experience by removing the need for manual clutch operation by the driver. Computer-controlled clutch actuating systems work particularly well in dual clutch systems where one clutch controls gear changes of even-numbered gear ratios, and a second clutch that controls gear changes of odd-numbered ratios.

Difficulty Level (Easy)
Level
Repair Time (45 Min.)
Time
Cost Prediction : $ 80-170

U2611 Error Code Repair Process :

The rule of U2611 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of scp (j1850) invalid or missing data for primary id. Likewise, overriding the OBD U2611 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Wrench Tool U2611 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Common Causes of U2611

A common cause of code U2611 is the failure of SCP (J1850) Invalid or Missing Data for Primary Id, but there are several other possible causes as well, such as ;

U2611 code for all cars

You can view according U2611 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+U2611 Mazda Tribute +U2611 Proton Inspira +U2611 Mercury Cyclone +U2611 Ford Quadricycle +U2611 Opel P 1200

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved