U2539 Subaru Outback 3 OBD Code

OBD/2 U2539 error code description and symptoms.

Brake Switch Circuit Input Malfunction Indicates PCM did not receive a brake pedal position (BPP) input. Open or short in BPP circuit Open or short in stoplamp circuits Damaged PCM Malfunction in module(s) connected to BPP circuit. (Rear Electronic Module [REM] Windstar and LS6/LS8 or Lighting Control Module (LCM) Continental and Town Car. Damaged brake switch Misadjusted brake switch Check for proper function of stoplamps.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

U2539 Subaru Outback 3 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U2539 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If air suspension front inflator solenoid output circuit short to ground so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the air suspension front inflator solenoid output circuit short to ground.

Common Causes of Subaru Outback 3 U2539 OBD2 Code

A common cause of code U2539 is the failure of Air Suspension Front Inflator Solenoid Output Circuit Short To Ground, but there are several other possible causes as well, such as ;

Failures of clutch motion/travel sensors.
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Incorrect fuel pressure

U2539 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2539 Subaru Outback 3 OBD Code

U2539 Subaru Outback 3 Error Code Repair Process :

Common Causes of Subaru Outback 3 U2539 OBD2 Code

U2539 code for other Subaru cars