U2377 Audi S1 OBD Code

OBD/2 U2377 error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

U2377 Audi S1 Error Code Repair Process :

If your motor # 2 input circuit short to vbat check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U2377 and engine control unit are in charge of monitoring a bunch of different motor # 2 input circuit short to vbat, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Audi S1 U2377 OBD2 Code

A common cause of code U2377 is the failure of Motor # 2 Input Circuit Short to Vbat, but there are several other possible causes as well, such as ;

EVAP canister or fuel tank leaks
Faulty spark plug (s)
Engine Control Module (ECM)
Damaged camshaft position (CMP) sensor

U2377 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2377 Audi S1 OBD Code

U2377 Audi S1 Error Code Repair Process :

Common Causes of Audi S1 U2377 OBD2 Code

U2377 code for other Audi cars