U2376 Mercedes E 300 OBD Code

OBD/2 U2376 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC U2376 as an indication of a hard fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

U2376 Mercedes E 300 Error Code Repair Process :

If your motor # 2 input circuit failure check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U2376 and engine control unit are in charge of monitoring a bunch of different motor # 2 input circuit failure, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Mercedes E 300 U2376 OBD2 Code

A common cause of code U2376 is the failure of Motor # 2 Input Circuit Failure, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty ignition coil (s)
Faulty oil control valve (OCV)
Faulty select solenoid

U2376 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U2376 Mercedes E 300 OBD Code

U2376 Mercedes E 300 Error Code Repair Process :

Common Causes of Mercedes E 300 U2376 OBD2 Code

U2376 code for other Mercedes cars