U228D Citroen C1 Ii OBD Code

OBD/2 U228D error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

As long as the throttle plate remains closed, the idling speed and quality is controlled by the PCM via the idle control valve, and as can be seen from the above it should be clear that idle control on a gasoline engine is a complex affair. For instance, if the engine is started in sub-zero temperatures, the PCM will command the idling control valve to allow less air to enter the engine to enrich the air/fuel mixture to create a condition which is roughly analogous to how chokes worked on carburetted engines to control idling in cold weather.

U228D Citroen C1 Ii Error Code Repair Process :

If your speed wheel sensor lr coherency fault check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U228D and engine control unit are in charge of monitoring a bunch of different speed wheel sensor lr coherency fault, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Citroen C1 Ii U228D OBD2 Code

A common cause of code U228D is the failure of Speed Wheel Sensor LR Coherency Fault, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty ignition coil (s)
Camshaft advance mechanism binding (VCT unit)

U228D is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U228D Citroen C1 Ii OBD Code

U228D Citroen C1 Ii Error Code Repair Process :

Common Causes of Citroen C1 Ii U228D OBD2 Code

U228D code for other Citroen cars