U1934 Volkswagen Jetta OBD Code

OBD/2 U1934 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

U1934 Volkswagen Jetta Error Code Repair Process :

For seatbelt driver pretensioner circuit open check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. U1934 error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks seatbelt driver pretensioner circuit open with your car's computers to find out exactly what's prompting the light to turn on.

Common Causes of Volkswagen Jetta U1934 OBD2 Code

A common cause of code U1934 is the failure of Seatbelt Driver Pretensioner Circuit Open, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Exhaust tube
Faulty Intake Valve Timing Control Solenoid Valve
Ignition coils harness is open or shorted

U1934 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U1934 Volkswagen Jetta OBD Code

U1934 Volkswagen Jetta Error Code Repair Process :

Common Causes of Volkswagen Jetta U1934 OBD2 Code

U1934 code for other Volkswagen cars