U1809 Suzuki Fronte OBD Code

OBD/2 U1809 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

As the engine heats up and combustion becomes easier and more complete, the PCM will command the idling control valve to increase the amount of air entering the engine to suit the changing conditions. However, when the load on the engine changes, say, when some electrical consumers or other systems are either turned on or off, the PCM adapts the signal voltage to the idle control valve to ensure that the idling speed remains stable, and at the RPM specified by the manufacturer.

U1809 Suzuki Fronte Error Code Repair Process :

If your park/neutral switch circuit short to battery check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U1809 and engine control unit are in charge of monitoring a bunch of different park/neutral switch circuit short to battery, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Suzuki Fronte U1809 OBD2 Code

A common cause of code U1809 is the failure of Park/Neutral Switch Circuit Short To Battery, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty front heated oxygen sensor
Fuel filler cap remains open or fails to close
Open or short in the CMP sensor circuits

U1809 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U1809 Suzuki Fronte OBD Code

U1809 Suzuki Fronte Error Code Repair Process :

Common Causes of Suzuki Fronte U1809 OBD2 Code

U1809 code for other Suzuki cars