U1449 Peugeot 307 OBD Code

OBD/2 U1449 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

As the engine heats up and combustion becomes easier and more complete, the PCM will command the idling control valve to increase the amount of air entering the engine to suit the changing conditions. However, when the load on the engine changes, say, when some electrical consumers or other systems are either turned on or off, the PCM adapts the signal voltage to the idle control valve to ensure that the idling speed remains stable, and at the RPM specified by the manufacturer.

U1449 Peugeot 307 Error Code Repair Process :

The rule of U1449 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of oil level lamp circuit short to ground. Likewise, overriding the OBD U1449 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Peugeot 307 U1449 OBD2 Code

A common cause of code U1449 is the failure of Oil Level Lamp Circuit Short To Ground, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Faulty select solenoid
Intake Valve Timing Control Solenoid Valve circuit poor electrical connection
Faulty starter motor

U1449 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U1449 Peugeot 307 OBD Code

U1449 Peugeot 307 Error Code Repair Process :

Common Causes of Peugeot 307 U1449 OBD2 Code

U1449 code for other Peugeot cars