U1449 Holden Drover OBD Code

OBD/2 U1449 error code description and symptoms.

HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

U1449 Holden Drover Error Code Repair Process :

For oil level lamp circuit short to ground check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. U1449 error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks oil level lamp circuit short to ground with your car's computers to find out exactly what's prompting the light to turn on.

Common Causes of Holden Drover U1449 OBD2 Code

A common cause of code U1449 is the failure of Oil Level Lamp Circuit Short To Ground, but there are several other possible causes as well, such as ;

Exhaust tube
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty Mass Air Flow (MAF) sensor
Faulty TCM or TCM programming

U1449 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U1449 Holden Drover OBD Code

U1449 Holden Drover Error Code Repair Process :

Common Causes of Holden Drover U1449 OBD2 Code

U1449 code for other Holden cars