U1413 Toyota Hi-ace OBD Code

OBD/2 U1413 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC U1413 as an indication of a hard fault.

A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting. You will want to test the fuses with circuits loaded. Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.

U1413 Toyota Hi-ace Error Code Repair Process :

If your heated backlite relay short to ground check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U1413 and engine control unit are in charge of monitoring a bunch of different heated backlite relay short to ground, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Toyota Hi-ace U1413 OBD2 Code

A common cause of code U1413 is the failure of Heated Backlite Relay Short To Ground, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Engine Control Module (ECM)
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Camshaft advance mechanism binding (VCT unit)

U1413 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U1413 Toyota Hi-ace OBD Code

U1413 Toyota Hi-ace Error Code Repair Process :

Common Causes of Toyota Hi-ace U1413 OBD2 Code

U1413 code for other Toyota cars