U1316 Honda N360 OBD Code

OBD/2 U1316 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

U1316 Honda N360 Error Code Repair Process :

If your air temperature internal sensor circuit short to ground check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U1316 and engine control unit are in charge of monitoring a bunch of different air temperature internal sensor circuit short to ground, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Honda N360 U1316 OBD2 Code

A common cause of code U1316 is the failure of Air Temperature Internal Sensor Circuit Short To Ground, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Dirty Oil
Intake Valve Timing Control Solenoid Valve circuit poor electrical connection
Incorrect fuel filler cap used

U1316 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U1316 Honda N360 OBD Code

U1316 Honda N360 Error Code Repair Process :

Common Causes of Honda N360 U1316 OBD2 Code

U1316 code for other Honda cars