U1302 Triumph Dolomite OBD Code

OBD/2 U1302 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

U1302 Triumph Dolomite Error Code Repair Process :

If your over temperature fault check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U1302 and engine control unit are in charge of monitoring a bunch of different over temperature fault, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Triumph Dolomite U1302 OBD2 Code

A common cause of code U1302 is the failure of Over Temperature Fault, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Damaged camshaft position (CMP) sensor
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty Variable Camshaft Timing (VCT) position solenoid

U1302 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U1302 Triumph Dolomite OBD Code

U1302 Triumph Dolomite Error Code Repair Process :

Common Causes of Triumph Dolomite U1302 OBD2 Code

U1302 code for other Triumph cars