U0557 Trouble Code

View U0557 obd/2 error code description and symptoms. U0557 engine photo

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC U0557 as an indication of a hard fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code U0557, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code U0557 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

Difficulty Level (Soso)
Level
Repair Time (50 Min.)
Time
Cost Prediction : $ 60-110

U0557 Error Code Repair Process :

The rule of U0557 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of output speed sensor circuit malfunction. Likewise, overriding the OBD U0557 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Wrench Tool U0557 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Common Causes of U0557

A common cause of code U0557 is the failure of Output Speed Sensor Circuit Malfunction, but there are several other possible causes as well, such as ;

U0557 code for all cars

You can view according U0557 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+U0557 Mg Zs +U0557 Dodge Sidewinder +U0557 Mini Ii +U0557 Saab Sonett +U0557 Sunbeam 30

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved