U0500 Chevrolet Silverado OBD Code

OBD/2 U0500 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

U0500 Chevrolet Silverado Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U0500 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If engine oil pressure sensor/switch circuit range/performance so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the engine oil pressure sensor/switch circuit range/performance.

Common Causes of Chevrolet Silverado U0500 OBD2 Code

A common cause of code U0500 is the failure of Engine Oil Pressure Sensor/Switch Circuit Range/Performance, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty Fuel injector

U0500 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U0500 Chevrolet Silverado OBD Code

U0500 Chevrolet Silverado Error Code Repair Process :

Common Causes of Chevrolet Silverado U0500 OBD2 Code

U0500 code for other Chevrolet cars