U0399 Jaguar X-300 OBD Code

OBD/2 U0399 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

Circuit High Input codes like U0399 are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.

U0399 Jaguar X-300 Error Code Repair Process :

The rule of U0399 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of knock sensor 1 circuit malfunction (bank 1 or single sensor). Likewise, overriding the OBD U0399 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Jaguar X-300 U0399 OBD2 Code

A common cause of code U0399 is the failure of Knock Sensor 1 Circuit Malfunction (Bank 1 or Single Sensor), but there are several other possible causes as well, such as ;

Damaged VCT phaser
Erratic camshaft position due to low oil pressure
Ignition misfiring
Loss of ground.

U0399 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U0399 Jaguar X-300 OBD Code

U0399 Jaguar X-300 Error Code Repair Process :

Common Causes of Jaguar X-300 U0399 OBD2 Code

U0399 code for other Jaguar cars