U029E Trouble Code

View U029E obd/2 error code description and symptoms. U029E engine photo

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

Difficulty Level (Soso)
Level
Repair Time (50 Min.)
Time
Cost Prediction : $ 30-110

U029E Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U029E light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If cold start injector 1 malfunction so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the cold start injector 1 malfunction.

Wrench Tool U029E is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Common Causes of U029E

A common cause of code U029E is the failure of Cold Start Injector 1 Malfunction, but there are several other possible causes as well, such as ;

U029E code for all cars

You can view according U029E DTC for your car model. We selected several models to see obd2 solutions click and view it.

+U029E Ferrari 375 +U029E Willys-overland Whippet +U029E Bmw R 1200 Gs +U029E Nissan Cefiro +U029E Mazda Mazda 2 Iii

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved