Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.
Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code P7A10, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code P7A10 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.
If your check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P7A10 and engine control unit are in charge of monitoring a bunch of different , and if they get a reading that's a little out of whack, up pops the check engine light.
Difficulty Level (Soso)
|
Repair Time (50 Min.)
|
| Cost Prediction : $ 40-75 |
|
P7A10 is a kind of Powertrain Trouble Code
Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air. |
You can view according P7A10 DTC for your car model. We selected several models to see obd2 solutions click and view it.
Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.
Copyright 2017 © All rights reserved