P3745 Mitsubishi Endeavor OBD Code

OBD/2 P3745 error code description and symptoms.

The Transmission Fluid Pressure Switch allows the engine's control module (PCM) or Transmission Control Module (TCM) to use hydraulic fluid to engage the clutches in the transmission to allow for smoother shifting while driving. If the PCM or TCM detects an issue with the hydraulic clutch or the pressure switch, the PCM or TCM will set code P3745

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

P3745 Mitsubishi Endeavor Error Code Repair Process :

If your vehicle failed a P3745 test and the P3745 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses transfer case unable to transition between 2h and 4h a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look transfer case unable to transition between 2h and 4h: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Common Causes of Mitsubishi Endeavor P3745 OBD2 Code

A common cause of code P3745 is the failure of Transfer Case unable to transition between 2H and 4H, but there are several other possible causes as well, such as ;

Continuous oil flow to the VCT piston chamber
Faulty Fuel injector
1Camshaft Position Sensor circuit poor electrical connection
Lack of fuel

P3745 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P3745 Mitsubishi Endeavor OBD Code

P3745 Mitsubishi Endeavor Error Code Repair Process :

Common Causes of Mitsubishi Endeavor P3745 OBD2 Code

P3745 code for other Mitsubishi cars