P3430 Holden Maloo OBD Code

OBD/2 P3430 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

P3430 Holden Maloo Error Code Repair Process :

If your p3430 cylinder 4 exhaust valve control circuit performance check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P3430 and engine control unit are in charge of monitoring a bunch of different p3430 cylinder 4 exhaust valve control circuit performance, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Holden Maloo P3430 OBD2 Code

A common cause of code P3430 is the failure of P3430 Cylinder 4 Exhaust Valve Control Circuit Performance, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Damaged camshaft position (CMP) sensor
Damaged ECM
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1

P3430 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P3430 Holden Maloo OBD Code

P3430 Holden Maloo Error Code Repair Process :

Common Causes of Holden Maloo P3430 OBD2 Code

P3430 code for other Holden cars