P2941 Volvo 780 OBD Code

OBD/2 P2941 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Regardless of the design though, the purpose of all clutch actuating systems is to improve the driving experience by removing the need for manual clutch operation by the driver. Computer-controlled clutch actuating systems work particularly well in dual clutch systems where one clutch controls gear changes of even-numbered gear ratios, and a second clutch that controls gear changes of odd-numbered ratios.

P2941 Volvo 780 Error Code Repair Process :

The rule of P2941 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of wiper rear motor down relay coil circuit open. Likewise, overriding the OBD P2941 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Volvo 780 P2941 OBD2 Code

A common cause of code P2941 is the failure of Wiper Rear Motor Down Relay Coil Circuit Open, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Exhaust gas leaks
Faulty Crankshaft Position Sensor (POS)
Variable Camshaft Timing (VCT) position circuit poor electrical connection

P2941 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P2941 Volvo 780 OBD Code

P2941 Volvo 780 Error Code Repair Process :

Common Causes of Volvo 780 P2941 OBD2 Code

P2941 code for other Volvo cars