P2932 Trouble Code

View P2932 obd/2 error code description and symptoms. P2932 engine photo

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

Difficulty Level (Expert)
Level
Repair Time (35 Min.)
Time
Cost Prediction : $ 60-110

P2932 Error Code Repair Process :

The rule of P2932 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of lamp tail output circuit failure. Likewise, overriding the OBD P2932 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Wrench Tool P2932 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Common Causes of P2932

A common cause of code P2932 is the failure of Lamp Tail Output Circuit Failure, but there are several other possible causes as well, such as ;

P2932 code for all cars

You can view according P2932 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+P2932 Fiat 850 +P2932 Duesenberg J +P2932 Mercedes C 270 +P2932 Datsun 1000 +P2932 Ferrari P4/5

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved