P2928 Toyota Hi-ace OBD Code

OBD/2 P2928 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC P2928 as an indication of a hard fault.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

P2928 Toyota Hi-ace Error Code Repair Process :

If your lamp turn signal rear output circuit failure check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P2928 and engine control unit are in charge of monitoring a bunch of different lamp turn signal rear output circuit failure, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Toyota Hi-ace P2928 OBD2 Code

A common cause of code P2928 is the failure of Lamp Turn Signal Rear Output Circuit Failure, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty Variable Camshaft Timing (VCT) position solenoid
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Variable Camshaft Timing (VCT) position circuit is open or shorted

P2928 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P2928 Toyota Hi-ace OBD Code

P2928 Toyota Hi-ace Error Code Repair Process :

Common Causes of Toyota Hi-ace P2928 OBD2 Code

P2928 code for other Toyota cars