P2813 Pontiac Banshee OBD Code

OBD/2 P2813 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC P2813 as an indication of a hard fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

P2813 Pontiac Banshee Error Code Repair Process :

If your p2813 pressure control solenoid g control circuit range/performance check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P2813 and engine control unit are in charge of monitoring a bunch of different p2813 pressure control solenoid g control circuit range/performance, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Pontiac Banshee P2813 OBD2 Code

A common cause of code P2813 is the failure of P2813 Pressure Control Solenoid G Control Circuit Range/Performance, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty front heated oxygen sensor
Camshaft advance mechanism binding (VCT unit)
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection

P2813 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P2813 Pontiac Banshee OBD Code

P2813 Pontiac Banshee Error Code Repair Process :

Common Causes of Pontiac Banshee P2813 OBD2 Code

P2813 code for other Pontiac cars