P279B Pontiac Ventura OBD Code

OBD/2 P279B error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code P279B, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code P279B on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

P279B Pontiac Ventura Error Code Repair Process :

The rule of P279B code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of p279b transfer case gear low incorrect ratio. Likewise, overriding the OBD P279B error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Pontiac Ventura P279B OBD2 Code

A common cause of code P279B is the failure of P279B Transfer Case Gear Low Incorrect Ratio, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Faulty front heated oxygen sensor
Ignition misfiring
Erratic camshaft position due to low oil pressure

P279B is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P279B Pontiac Ventura OBD Code

P279B Pontiac Ventura Error Code Repair Process :

Common Causes of Pontiac Ventura P279B OBD2 Code

P279B code for other Pontiac cars