P2799 Mercedes-benz 200 OBD Code

OBD/2 P2799 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

P2799 Mercedes-benz 200 Error Code Repair Process :

The rule of P2799 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of p2799 auxiliary transmission fluid pump control circuit high. Likewise, overriding the OBD P2799 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Difficulty Level (Expert)
Level
Repair Time (35 Min.)
Time
Cost Prediction : $ 60-110

Common Causes of Mercedes-benz 200 P2799 OBD2 Code

A common cause of code P2799 is the failure of P2799 Auxiliary Transmission Fluid Pump Control Circuit High, but there are several other possible causes as well, such as ;
Wrench Tool P2799 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

P2799 code for other Mercedes-benz cars

You can view according P2799 DTC for your car model. We selected several models to see obd2 solutions click and view it.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved