P2711 Volkswagen 1300 OBD Code

OBD/2 P2711 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

P2711 Volkswagen 1300 Error Code Repair Process :

If your p2711 unexpected mechanical gear disengagement check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P2711 and engine control unit are in charge of monitoring a bunch of different p2711 unexpected mechanical gear disengagement, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Volkswagen 1300 P2711 OBD2 Code

A common cause of code P2711 is the failure of P2711 Unexpected Mechanical Gear Disengagement, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty select solenoid
Foreign matter caught in fuel filler cap
Erratic camshaft position due to low oil pressure

P2711 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P2711 Volkswagen 1300 OBD Code

P2711 Volkswagen 1300 Error Code Repair Process :

Common Causes of Volkswagen 1300 P2711 OBD2 Code

P2711 code for other Volkswagen cars