P2708 Trouble Code

View P2708 obd/2 error code description and symptoms. P2708 engine photo

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

P2708 Error Code Repair Process :

If your p2708 shift solenoid f stuck on check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P2708 and engine control unit are in charge of monitoring a bunch of different p2708 shift solenoid f stuck on, and if they get a reading that's a little out of whack, up pops the check engine light.

P2708 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Common Causes of P2708

A common cause of code P2708 is the failure of P2708 Shift Solenoid F Stuck On, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Damaged VCT phaser
Clogged or faulty fuel injector (s)
Damaged VCT phaser

P2708 code for all cars

You can view according P2708 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+P2708 Glas S

+P2708 Alvis Silver

+P2708 Sunbeam 4-litres

+P2708 Kia Forte

+P2708 Ford Pilot

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy