P2614 Holden Monaro OBD Code

OBD/2 P2614 error code description and symptoms.

Variable Cam Timing Over-advanced (Bank 1) The comprehensive component monitor (CCM) monitors the VCT position for an over-advanced camshaft timing.
The test fails when the camshaft timing exceeds a maximum calibrated value or remains in an advanced position. Cam timing improperly set No oil flow to the VCT piston chamber Low oil pressure VCT solenoid valve stuck closed Camshaft advance mechanism binding (VCT unit) P2614 DTC is a check of the VCT unit.

As the engine heats up and combustion becomes easier and more complete, the PCM will command the idling control valve to increase the amount of air entering the engine to suit the changing conditions. However, when the load on the engine changes, say, when some electrical consumers or other systems are either turned on or off, the PCM adapts the signal voltage to the idle control valve to ensure that the idling speed remains stable, and at the RPM specified by the manufacturer.

P2614 Holden Monaro Error Code Repair Process :

The rule of P2614 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of p2614 camshaft position signal output circuit/open. Likewise, overriding the OBD P2614 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Holden Monaro P2614 OBD2 Code

A common cause of code P2614 is the failure of P2614 Camshaft Position Signal Output Circuit/Open, but there are several other possible causes as well, such as ;

Camshaft advance mechanism binding (VCT unit)
EVAP canister or fuel tank leaks
EVAP system hose leaking
Faulty Air Flow Meter

P2614 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P2614 Holden Monaro OBD Code

P2614 Holden Monaro Error Code Repair Process :

Common Causes of Holden Monaro P2614 OBD2 Code

P2614 code for other Holden cars