P2610 Mercury Comet OBD Code

OBD/2 P2610 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

P2610 Mercury Comet Error Code Repair Process :

The rule of P2610 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of p2610 ecm/pcm internal engine off timer performance. Likewise, overriding the OBD P2610 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Difficulty Level (Expert)
Level
Repair Time (35 Min.)
Time
Cost Prediction : $ 60-110

Common Causes of Mercury Comet P2610 OBD2 Code

A common cause of code P2610 is the failure of P2610 ECM/PCM Internal Engine Off Timer Performance, but there are several other possible causes as well, such as ;
Wrench Tool P2610 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

P2610 code for other Mercury cars

You can view according P2610 DTC for your car model. We selected several models to see obd2 solutions click and view it.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved