P2400 Trouble Code

View P2400 obd/2 error code description and symptoms.

Variable Cam Timing Over-advanced (Bank 1) The comprehensive component monitor (CCM) monitors the VCT position for an over-advanced camshaft timing.
The test fails when the camshaft timing exceeds a maximum calibrated value or remains in an advanced position. Cam timing improperly set No oil flow to the VCT piston chamber Low oil pressure VCT solenoid valve stuck closed Camshaft advance mechanism binding (VCT unit) P2400 DTC is a check of the VCT unit.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

Difficulty Level (Soso)

Repair Time (50 Min.)

Cost Prediction : $ 30-110

P2400 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine P2400 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If p2400 evaporative emission system leak detection pump control circuit/open so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the p2400 evaporative emission system leak detection pump control circuit/open.

P2400 is a kind of Powertrain Trouble Code Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Common Causes of P2400

A common cause of code P2400 is the failure of P2400 Evaporative Emission System Leak Detection Pump Control Circuit/Open, but there are several other possible causes as well, such as ;

• Camshaft advance mechanism binding (VCT unit)
• Damaged camshaft position (CMP) sensor
• Faulty variable valve timing (VVT)
• Ignition misfiring

P2400 code for all cars

You can view according P2400 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+P2400 Mercedes-benz 170

+P2400 Chrysler Crown

+P2400 Maserati Coupe

+P2400 Alfa Romeo Alfasud

+P2400 Mazda 1400

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved