P2005 Buick 40 OBD Code

OBD/2 P2005 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

On some transmissions, such as automated manual transmissions or automatic transmissions with manual mode, the GSP switch lets the TCM know whether or not the driver has selected automatic or manual function. On manual transmissions, the GSP switch informs the TCM which gear the driver is selecting, and may function as a neutral safety switch, depending on system design. The TCM also uses the gate select position switch to monitor transmission operation. For example, if the driver selects manual mode and selects 3rd gear on an automatic transmission, the TCM may monitor speed sensors to detect clutch and brake slippage.

P2005 Buick 40 Error Code Repair Process :

The scent may P2005 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such P2005, so if the inside of your car p2005 intake manifold runner control stuck open bank 2 as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Common Causes of Buick 40 P2005 OBD2 Code

A common cause of code P2005 is the failure of P2005 Intake Manifold Runner Control Stuck Open Bank 2, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty Variable Camshaft Timing (VCT) position solenoid
Fuel injectors may be faulty
Damaged ECM

P2005 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P2005 Buick 40 OBD Code

P2005 Buick 40 Error Code Repair Process :

Common Causes of Buick 40 P2005 OBD2 Code

P2005 code for other Buick cars