P1430 Mercury Mountaineer Iii OBD Code

OBD/2 P1430 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

P1430 Mercury Mountaineer Iii Error Code Repair Process :

If your p1430 electric air pump secondary failure check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P1430 and engine control unit are in charge of monitoring a bunch of different p1430 electric air pump secondary failure, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Mercury Mountaineer Iii P1430 OBD2 Code

A common cause of code P1430 is the failure of P1430 Electric Air Pump Secondary Failure, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Camshaft advance mechanism binding (VCT unit)
Faulty select solenoid
Variable Camshaft Timing (VCT) position circuit is open or shorted

P1430 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P1430 Mercury Mountaineer Iii OBD Code

P1430 Mercury Mountaineer Iii Error Code Repair Process :

Common Causes of Mercury Mountaineer Iii P1430 OBD2 Code

P1430 code for other Mercury cars