P1258 Trouble Code

View P1258 obd/2 error code description and symptoms. P1258 engine photo

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code P1258, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code P1258 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

P1258 Error Code Repair Process :

The rule of P1258 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of p1258 pedal correlation pds1 and pds2. Likewise, overriding the OBD P1258 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

P1258 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Common Causes of P1258

A common cause of code P1258 is the failure of P1258 Pedal Correlation PDS1 and PDS2, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Camshaft Position Sensor harness is open or shorted
Intake Valve Timing Control Solenoid Valve circuit poor electrical connection
Clogged or faulty fuel injector (s)

P1258 code for all cars

You can view according P1258 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+P1258 Volkswagen Caddy 4

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy