P1235 Audi S2 OBD Code

OBD/2 P1235 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

P1235 Audi S2 Error Code Repair Process :

If your p1235 fuel pump control out of range check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P1235 and engine control unit are in charge of monitoring a bunch of different p1235 fuel pump control out of range, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Audi S2 P1235 OBD2 Code

A common cause of code P1235 is the failure of P1235 Fuel Pump Control Out Of Range, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Faulty ignition coil (s)
Clogged or faulty fuel injector (s)
Continuous oil flow to the VCT piston chamber

P1235 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P1235 Audi S2 OBD Code

P1235 Audi S2 Error Code Repair Process :

Common Causes of Audi S2 P1235 OBD2 Code

P1235 code for other Audi cars