The Camshaft Position sensor will signal the Engine Control Module when the #1 cylinder is ready for the spark plug to fire (top-dead-center on compression stroke). The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.
Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.
If your check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P107F and engine control unit are in charge of monitoring a bunch of different , and if they get a reading that's a little out of whack, up pops the check engine light.
Difficulty Level (Expert)
|
Repair Time (35 Min.)
|
| Cost Prediction : $ 40-75 |
|
P107F is a kind of Powertrain Trouble Code
Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air. |
You can view according P107F DTC for your car model. We selected several models to see obd2 solutions click and view it.
Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.
Copyright 2017 © All rights reserved