P1030 Mazda Mx-6 OBD Code

OBD/2 P1030 error code description and symptoms.

HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

P1030 Mazda Mx-6 Error Code Repair Process :

If your vehicle failed a P1030 test and the P1030 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses abs inlet valve coil rear circuit short to battery a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look abs inlet valve coil rear circuit short to battery: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Common Causes of Mazda Mx-6 P1030 OBD2 Code

A common cause of code P1030 is the failure of ABS Inlet Valve Coil Rear Circuit Short To Battery, but there are several other possible causes as well, such as ;

Exhaust tube
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Variable Camshaft Timing solenoid stuck open

P1030 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P1030 Mazda Mx-6 OBD Code

P1030 Mazda Mx-6 Error Code Repair Process :

Common Causes of Mazda Mx-6 P1030 OBD2 Code

P1030 code for other Mazda cars