P0C53 Hyundai Tuscon OBD Code

OBD/2 P0C53 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

P0C53 Hyundai Tuscon Error Code Repair Process :

If your aux a/c blower motor relay circuit short to ground check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P0C53 and engine control unit are in charge of monitoring a bunch of different aux a/c blower motor relay circuit short to ground, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Hyundai Tuscon P0C53 OBD2 Code

A common cause of code P0C53 is the failure of Aux A/C Blower Motor Relay Circuit Short to Ground, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Fuel injectors may be faulty
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection

P0C53 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P0C53 Hyundai Tuscon OBD Code

P0C53 Hyundai Tuscon Error Code Repair Process :

Common Causes of Hyundai Tuscon P0C53 OBD2 Code

P0C53 code for other Hyundai cars