P0B6C Fiat Tempra OBD Code

OBD/2 P0B6C error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code P0B6C, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code P0B6C on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

P0B6C Fiat Tempra Error Code Repair Process :

The rule of P0B6C code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of low coolant lamp output circuit short to battery. Likewise, overriding the OBD P0B6C error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Fiat Tempra P0B6C OBD2 Code

A common cause of code P0B6C is the failure of Low Coolant Lamp Output Circuit Short to Battery, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Faulty Camshaft Position Sensor
Incorrect Positive Crankcase Ventilation (PCV) hose connection

P0B6C is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P0B6C Fiat Tempra OBD Code

P0B6C Fiat Tempra Error Code Repair Process :

Common Causes of Fiat Tempra P0B6C OBD2 Code

P0B6C code for other Fiat cars