P0B1C Land Rover Range Rover OBD Code

OBD/2 P0B1C error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

P0B1C Land Rover Range Rover Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine P0B1C light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If driver side so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the driver side.

Difficulty Level (Expert)

Repair Time (35 Min.)

Cost Prediction : $ 30-110

Common Causes of Land Rover Range Rover P0B1C OBD2 Code

A common cause of code P0B1C is the failure of Driver Side, but there are several other possible causes as well, such as ;

• EVAP canister or fuel tank leaks
• Failures of clutch motion/travel sensors.
• Faulty spark plug (s)
• Fuel filler cap remains open or fails to close

P0B1C is a kind of Powertrain Trouble Code Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

P0B1C code for other Land cars

You can view according P0B1C DTC for your car model. We selected several models to see obd2 solutions click and view it.

• P0B1C Land Rover Defender
• P0B1C Land Rover Discovery
• P0B1C Land Rover Discovery 2
• P0B1C Land Rover Discovery 3
• P0B1C Land Rover Discovery 4
• P0B1C Land Rover Discovery 5
• P0B1C Land Rover Evoque
• P0B1C Land Rover Freelander
• P0B1C Land Rover Freelander 2
• P0B1C Land Rover Lr2
• P0B1C Land Rover Lr3
• P0B1C Land Rover Serie I
• P0B1C Land Rover Series I
• P0B1C Land Rover Series Ii
• P0B1C Land Rover Series Iii
• P0B1C Land Rover Velar

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved