P081E Saab Aero-x OBD Code

OBD/2 P081E error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

Circuit High Input codes like P081E are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.

P081E Saab Aero-x Error Code Repair Process :

If your wiper low speed circuit motor failure check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P081E and engine control unit are in charge of monitoring a bunch of different wiper low speed circuit motor failure, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Saab Aero-x P081E OBD2 Code

A common cause of code P081E is the failure of Wiper Low Speed Circuit Motor Failure, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Erratic camshaft position due to low oil pressure
Engine Control Module (ECM)
Faulty Fuel injector

P081E is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

P081E Saab Aero-x OBD Code

P081E Saab Aero-x Error Code Repair Process :

Common Causes of Saab Aero-x P081E OBD2 Code

P081E code for other Saab cars